Terk HDTVO_OMЙ - Manual (Page 10)

8
To mount the HDTVo antenna on an outdoor wall using the mini-
mast (see fig. 3A):
1. Locate the HDTVo antenna and all included components.
2. Using the four lag screws, attach the mini-mast bracket to the
outdoor wall. Be sure to position the bracket vertically on the
outdoor wall.
3. Slide the straight end of the mini-mast into the mini-mast
bracket, and using the two nuts and the two bolts, secure the
mini-mast to the mini-mast bracket. Be sure to orient the
mini-mast as shown in the illustration
4. Using the four threaded bolts, the four washers and the four
nuts, attach the antenna bracket and the pole clamp to the
curved end of mini-mast.
5. Gently spread open the antenna’s two side reception elements.
6. Slide the back of the antenna into the antenna bracket.
7. Insert the 3” partially threaded bolt and the 3/8” screw into the
holes on the top of the antenna bracket, and partially tighten
the bolt.
8. With the 3” partially threaded bolt only partially tightened,
adjust the antenna so that it is precisely pointing towards the
broadcast tower (see “Positioning the HDTVo”).
9. Tighten the 3” partially threaded bolt and the 3/8” screw,
securing the antenna in the antenna bracket.
10. Skip to the “Connecting the HDTVo to a TV” section to
complete installation.
To mount the HDTVo antenna on an outdoor wall without using the
mini-mast (see fig. 3B):
1. Locate:
– The HDTVo antenna
– The four lag screws
– The antenna bracket
– The 3” partially threaded bolt and the 3/8” screw
2. Using the four lag screws, attach the antenna bracket to the
outdoor wall.
3. Gently spread open the antenna’s two side reception elements.
4. Slide the back of the antenna into the antenna bracket.
5. Insert the 3” partially threaded bolt and the 3/8” screw into the
hole on the top of the antenna bracket, and partially tighten the bolt.
6. With the 3” partially threaded bolt only partially tightened,
adjust the antenna so that it is precisely pointing towards the
broadcast tower (see “Positioning the HDTVo”).
7. Tighten the 3” partially threaded bolt and the 3/8” screw,
securing the antenna in the antenna bracket.
8. Skip to the “Connecting the HDTVo to a TV” section to complete
installation.
HD
TV
o