Terk HDTVO_OMЙ - Manual (Page 13)

11
To mount the HDTVo on a rafter located in an attic where the
roof that has 45-90 degree pitch (see fig. 5):
1. Locate the HDTVo antenna and all included components.
2. Using the four lag screws, attach the mini-mast bracket to
the rafter. Be sure to position the bracket vertically on the
rafter.
3. Slide the curved end of the mini-mast into the mini-mast
bracket, and using the two nuts and the two bolts, secure
the mini-mast to the mini-mast bracket. Be sure to orient
the mini-mast as shown in the illustration.
4. Using the four 1.75” threaded bolts, the four washers and
the four 1.75” nuts, attach the antenna bracket and the pole
clamp to the straight end of mini-mast.
5. Gently spread open the antenna’s two side reception
elements.
6. Slide the back of the antenna into the antenna bracket.
7. Insert the 3” partially threaded bolt into the hole on the top
of the antenna bracket, and partially tighten the bolt.
8. With the 3” partially threaded bolt only partially tightened,
adjust the antenna so that it is precisely pointing towards
the broadcast tower (see “Positioning the HDTVo”).
9. Tighten the 3” partially threaded bolt, securing the antenna
in the antenna bracket.
10. Skip to the “Connecting the HDTVo to a TV” section to
complete installation.
HD
TV
o
Fig 5.