Terk TV42_OMЙ - Manual (Page 8)

7
Connecting the TV42
(continued)
B - Triple LNB (Phase3) Satellite Dish
Note: You can only connect up to 2 receivers to your satellite dish
with the TV42. If you would like to use or eventually use up to 4
receivers, you will need to purchase the Terk TV44 antenna instead.
1. Remove the LNB from the arm of the satellite dish to expose
the satellite cables. See Fig 10.
2. Disconnect 2 satellite cable(s) from the satellite dish’s LNB and
pull them out through the bottom of the satellite dish arm.
See Fig 10.
3. Connect the satellite cables to the terminals marked
OUT 1 and OUT 2 on the TV42 antenna. See Fig 11.
TV42
Fig 11.
Fig 10.