Teledyne LeCroy USB2-HSIC Decoder User Manual
Page 10
USB2/USB2-HSIC Decode and Trigger
Enabling/Disabling the Decoder
Once preset, the four decoders can be enabled simultaneously or separately, although this number may be
limited depending on the type of source channels selected. Preset decoders can be easily disabled without
disrupting the configuration.
To enable:
Press the Front Panel Serial Decode button (if available on your oscilloscope), or choose Analysis > Serial
Decode, to open the Serial Decode dialog, then check Decode On next to the respective decoder.
If View Decode is checked (default) for that decoder on the Decode Setup dialog, a
and
appear. The number of rows of data displayed on each table will depend on the Table#Rows
setting. The default is one, which can be increased, but doing so will decrease the amount of the screen
available to display traces.
To disable:
Deselect the Decode On box individually, or touch Turn All Off.
8
922295 RevA