Teledyne LeCroy QPHY-USB3-Tx-Rx - Manual (Page 23)

QPHY-USB3-Tx-Rx Software Option
917719 Rev A
23

Test 1.1 – Low Frequency Periodic Signaling

Test 1.2 – Spread Spectrum Tests

Test 1.3 – Jitter & Eye Diagram Tests
o Test 1.3.1 – Jitter
o Test 1.3.2 – Phase Jitter Slew Rate
o Test 1.3.3 – SigTest Jitter
o Test 1.3.4 – Eye Diagram
o Test 1.3.5 – SigTest Eye Diagram

Test 1.4 – AC & DC Common Mode Test

Test 1.5 – Differential Voltage & De-emphasis Test
Host Scope PeRT3 (Host RX Tests)
This configuration is meant to run all of the receiver tests for a user that has a PeRT
3
but not the RF Switch. All
variables are set to default except Use PeRT3 is set to “Yes.” The limit set used is ComplianceLimits. The tests
that are run are:

Test 2.1. – Jitter Tolerance Test
Host Scope PeRT3 (Host TX and RX Tests)
This configuration is meant to run all of the transmitter and receiver tests for a user that has a PeRT
3
but not the
RF Switch. All of the variables are set to default except Use PeRT3 is set to “Yes.” The limit set used is
ComplianceLimits. The tests that are run are:

Test 1.1 – Low Frequency Periodic Signaling

Test 1.2 – Spread Spectrum Tests

Test 1.3 – Jitter & Eye Diagram Tests
o Test 1.3.1 – Jitter
o Test 1.3.2 – Phase Jitter Slew Rate
o Test 1.3.3 – SigTest Jitter
o Test 1.3.4 – Eye Diagram
o Test 1.3.5 – SigTest Eye Diagram

Test 1.4 – AC & DC Common Mode Test

Test 1.5 – Differential Voltage & De-emphasis Test

Test 2.1. – Jitter Tolerance Test
Host Scope PeRT3 (Host TX Tests)
This configuration is meant to run all of the transmitter tests for a user that has a PeRT
3
but not the RF Switch. All
of the variables are set to default except Use PeRT3 is set to “Yes.” The limit set is used is ComplianceLimits.
The tests that are run are:

Test 1.1 – Low Frequency Periodic Signaling

Test 1.2 – Spread Spectrum Tests