Teledyne LeCroy QPHY-USB3-Tx-Rx - Manual (Page 10)

10
917719 Rev A
QualiP HY tests the oscilloscope connection after clicking the Start button. The system prompts you if there is a
connection problem. QualiPHY’s Scope Selector function can also be used to verify the connection. Please refer
to the
QualiPHY Operator’s Manual for explanations on how to us e Scope Selector and other QualiPHY
functions.
Accessing the QPHY-USB3-Tx-Rx Software using QualiPHY
This topic provides a basic overview of QualiPHY’s capabilities. Please refer to the QualiPHY Operator’s Manual
for detailed information.
Access the QPHY-USB3-Tx -Rx software using the following steps:
1. Wait for the oscilloscope to start and have its main application running.
2. Launch QualiPHY from the Analysi s menu if installed on the oscilloscope or from the desktop icon if
installed on a host computer.
3. From the QualiP HY main window (as follows), select Standard, then USB3.0 SS from the pop-up menu
(if not already selected). If you check the Pause on Failure box (circled) QualiP HY prompts to retry the
measure whenever a test fails.
Figure 4. QualiPHY main menu and compliance test Standard selection menu