Teledyne LeCroy AGPAX - Manual (Page 6)

6
JUMPER TABLE
Description Jumper Utilization
Current measurement J3 Outputs to DVM
External power input J5 Inputs from external power supply
+5V isolation from the system JP5 On = voltage from system
Off = voltage from External supply
+12V isolation from the system JP6 On = voltage from system
Off = voltage from External supply
VCC3 isolation from the system JP7 On = voltage from system
Off = voltage from External supply
VDDQ isolation from the system JP9 On = voltage from system
Off = voltage from External supply
Disable Mechanical On-Off Switch SW On = S1 can control the board
Off = S1 is disabled
Remote On-Off JP15 Shunt On, Board Id is One
Shunt Off, Board Id is Two
JP16 Factory Use Only
LEDs
There are two sets of LED on the board, green and red. Each LED has a label which Voltage it represents. The green
LED, when lit, indicates presence of the corresponding voltage. The red LED, when lit, represent a short on the
corresponding voltage. Please note that the green LEDs do not indicate if the voltage is at the expected level or not.