Teledyne LeCroy NetMate - Users Manual - Manual (Page 16)

NetMate USB/Ethernet Link User’s Manual CATC
10
The software program will be automatically removed by Windows.
4. Specifying the TCP/IP Parameters
This configuration procedure is identical to that of other NICs, for
example, a 3COM Ethernet card. The following sections describe two
basic setups using the TCP/IP protocol.
A. When the CATC USB/Ethernet Link is the only installed NIC.
Select My Computer / Control Panel / Network.
The Network Configuration form appears. In this form, the
CATC USB/Ethernet Link NIC icon should be visible.
Additionally, a new protocol icon with the title TCP/IP should be
visible. To specify the TCP/IP parameters, use the procedure
described below.
B. When another NIC is already installed in the system.
Select My Computer / Control Panel / Network.
The Network Configuration form appears. In this form, the
CATC USB/Ethernet Link icon should be visible.
If the TCP/IP protocol was previously installed, a network connection
icon with the title TCP/IP -> CATC USB/Ethernet Link should also
be visible. To specify the TCP/IP parameters, use the procedure
described below.
To specify the TCP/IP parameters:
1. Select TCP/IP, (or TCP/IP -> CATC USB/Ethernet Link, if more
than one NIC is installed).
2. Click Properties.
3. Select Specify an IP Address.
4. Enter a valid IP address and Subnet Mask, per the instructions of
your local System Administrator.
5. Click OK.