Teledyne LeCroy NetMate - Users Manual - Manual (Page 14)

NetMate USB/Ethernet Link User’s Manual CATC
8
3. Installation
Your particular environment may require drive letters or folder
names different than those mentioned here. You may be asked to
specify file locations on the Windows CD, or on the software
installation diskette. For example:
– Windows might look on the A:\ drive for a file that is on a CD.
In this case, you would specify a search such as
D:\WIN95\OSR2\SETUP .
3.1 Automatic Installation:
Windows 95 and 98 Systems
This section outlines the quick and easy, automatic installation
procedure for the NetMate Link drivers.
Note: The installation program automatically detects if your computer
is properly configured and initialized for USB installation. If the
installation program aborts, see the
Troubleshooting section.
You may need to upgrade your computer.
Make connections when requested in the installation procedure,
illustrated in Figure 2-1.
The installation procedure assumes that this is a new driver
installation on a Windows system. The installation program
automatically recognizes if your operating system is Windows 95 and
98.
1. Close any Windows applications that may be running on your
computer.
2. Insert the software installation diskette in the floppy disk drive.
3. Connect the USB cable to your computer. Do not connect the
USB cable to the Link.
4. Connect the network cable to the network port and to the Link.
5. From the Windows Taskbar, select Start / Run.