Front panel description, Expansion module connections, Installing the software – Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer Quick Start Guide User Manual
Page 2
Front Panel Description
Features
The Analyzer has the following features on the front:
•
LED Indicators for I1-T1, I2-T2, I3-T3, and I4-T4 [1]
•
TRIGGER
or
for trigger
•
ERROR
or
for error
•
LINK
or
for link
•
SPEED
or
for speed level
1
•
FRAME/OOB
or
for OOB or traffic
2
•
Power Switch (0/1) [2]
•
External Trigger Input (TRIG IN) [3]
•
External Trigger Output (TRIG OUT) [3]
•
Initiator mini-SAS connector [4]
•
Target mini-SAS connector [5]
•
Expansion In/Out data ports and Clock In/Out connectors [6]
•
Status and Configuration LCD Display [7]
•
USB Port for host connectivity [8]
•
Ethernet Port for network connectivity [9]
1
SPEED LEDs
The orange LEDs for SPEED illuminate as follows:
Speed
Initiator
Target
1.5G
Off Off
3.0G
On
Off
6.0G
On
On
2
FRAME/OOB LEDs
The green LEDs for FRAME/OOB illuminate as follows:
•
Before the link is established, illuminates during the
OOB sequence.
•
After the link is established, indicates traffic on the bus.
1
2
3
8
9
4
5
7
6
4
Expansion Module Connections
The Analyzer provides cascading features through the
Expansion Module via the following connectors:
•
Expansion In/Out connectors [10]
•
Clock In/Out connectors [11]
Warning:
Do not open the enclosure. No operator
serviceable parts are inside.
Expansion
Clock
In
Out
In
Out
5
Installing the Software
Important! Do not connect Sierra M6-4 to your host system until software installation is complete.
1.
Insert the Installation CD ROM into the CD drive on the host machine. The installation automatically starts setup, unless Auto Run is
off. In that case, select the CD ROM from “My Computer” and click Setup.
After the warning to close all other programs and before starting the installation, the Install component selection opens.
2.
Select components for installation.
3.
Click Next to complete the installation. The Sierra M6-4 software installs on the PC hard disk.
4.
Restart the computer before using the software.
Note: If you get an error message during installation of the drivers, consult your system administrator.
6