Teledyne LeCroy PCI Express 2.0 Multi-Lead Probe for Summit T24 - Manual (Page 3)

7. Connect the power supply to the pod.
Clock
Connectors
on the POD
Connect a Clocking Cable
Assembly connector to "Clock
In" or "Clock Out" on the POD.
4
Software Configuration
The default configuration of the Gen2 Multi-Lead Probe Assembly is the (x4 width) configuration.
To use the Summit T24 Analyzer, you must first create the correct swizzling setup in the Recording Options dialog.
To setup the swizzling configuration:
1. Open the PETracer application on the host machine.
2. Open the Recording Options dialog.
3. In the Recording Type section (top left) your connected analyzer must be displayed.
4. In the Link section (on the right), select x4 as the link width.