Teledyne LeCroy PP008 - Manual (Page 16)

PP008 Passive Probe
14 922210-00 Rev A
Certifications
This section certifies the probe’ Safety and Environmental compliance.
EC Declaration of Conformity - Safety
The probe meets intent of EC Directive 2006/95/EC for Product Safety.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61010-031/A1:2008 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 031: Safety requirements for
hand-held probe assemblies for electrical measurement and test.

Measurement Category I (CAT I), measurement performed on circuits
not directly connected to a mains supply.

Measurement Category II (CAT II), measurements performed on circuits
directly connected to the low-voltage installation.

Pollution Degree 2, operating environment where normally only dry
non-conductive pollution occurs. Conductivity caused by temporary
condensation should be expected.
Environmental Compliance
E
ND
-O
F
-L
IFE
H
ANDLING
The probe is marked with this symbol to indicate that it complies
with the applicable European Union requirements to Directives
2002/96/EC and 2006/66/EC on Waste Electrical and Electronic
Equipment (WEEE) and Batteries.
The probe is subject to disposal and recycling regulations that
vary by country and region. Many countries prohibit the disposal
of waste electronic equipment in standard waste receptacles. For
more information about proper disposal and recycling of your
Teledyne LeCroy product, please visit teledynelecroy.com/recycle.
R
ESTRICTION OF
H
AZARDOUS
S
UBSTANCES
(R
O
HS)
This probe has been classified as Industrial Monitoring and Control Equipment
and is outside the scope of the 2011/65/EU RoHS Directive until 22 July 2017
(per Article 4, Paragraph 3).