Teledyne LeCroy WaveMaster 8000A - Manual (Page 39)

Getting Started Manual
WM-GS-E Rev E
37
Standard Horizontal Parameters
These are the default Standard Horizontal Parameters:
Horizontal
freq Frequency
period Period
width Width
rise Risetime
fall Fall time
delay Delay from trigger
duty duty cycle
npoints Number of points in
waveform
Custom Measurements with My Measure
You can choose to customize up to eight parameters by touching My Measure and then selecting
the measurements desired.
Parameter Analysis
Trend measurements
A trend of a measurement parameter is a line graph with a measurement point from each
subsequent signal acquisition plotted on the graph.
1. In the toolbar, touch Measure, then Measure Setup… in the drop-down menu.
2. Touch one of parameter tabs P1 through P8.
3. Touch inside the Source1 data entry field and select an input waveform from the pop-up
menu.
4. Touch inside the Measure data entry field and select a parameter from the pop-up menu.
5. Touch the Trend button at the bottom of the dialog.