Asus AP2400R-E1 - Manual (Page 37)

2-23 ASUS AP2400-E1 2U barebone server
2.6 Cable connections
The bundled system cables are pre-connected before shipment. You
do not need to disconnect these cables unless you will remove pre-
installed components to install additional devices.
Refer to this section when reconnecting cables to ensure correct cable
connections.
Pre-connected system cables
1. Rear fan connectors (from MB to rear fan board)
2. 24-pin/8-pin power connectors (from power supply to MB)
3. Floppy drive connector (from MB to floppy drive)
4. SMBus connector (from MB to SCSI board)
5. PANEL connectors (from MB to front panel)
6. Chassis intrusion connector (from MB to front panel)
7. SCSI-B connector (from MB to SCSI board or to external SCSI port)
8. SCSI-A connector (from MB to SCSI board)
9. Secondary IDE (from MB to optical drive)
10. Mid-fan power connector (from power supply to mid-fan board)
11. SCSI board connectors (from 3 SCSI boards to MB and power supply)
1
2
3
4
5 6
7
8
9
10
11