Staub Electronics D803-3D VIVITEK - 3D DIGITAL PROJECTOR (3600 LUMENS) - Manual (Page 48)

DLP Projector—User’s Manual
— 40 —
LED Error Messages
E RROR C ODE M ESSAGES
P OWER LED
G REEN
L AMP LED
R ED
T EMP LED
R ED
Ready to power on (Standby) ON － －
System Warm up Flash － －
Lamp Lit , System stable ON － －
Cooling Flashing － －
Over Temperature － － ON
Thermal Break Sensor error 4 blinks － －
Lamp Fail － ON －
Lamp over voltage 5 blinks 1 blinks －
Input voltage too high 5 blinks 2 blinks －
Temp too high 5 blinks 3 blinks －
Asymmetry detected 5 blinks 4 blinks －
Lamp under voltage 5 blinks 5 blinks －
Input voltage too low 5 blinks 6 blinks －
Axial Fan error 6 blinks 1 blinks －
Blower Fan error 6 blinks 2 blinks －
DMD Fan error 6 blinks 3 blinks －
Case Open 7 blinks － －
Color wheel error 9 blinks － －
Ballast communication error 10 blinks 1 blinks －
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before restarting
the projector. If the Power or Lamp LEDs are still blinking or any other situation that isn't listed in the chart
above, please contact your service center.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control.
3. Ensure the projector-to-screen distance is within the 10-meter (33-feet) specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone button on the remote control to correct the problem.
Problem: The image is reversed
Check the Projection setting on the Installation I menu of the OSD.
Problem: The image is streaked