Staub Electronics WB-600-IPVCE-12 WATTBOX - IP CONTROLLABLE 12 OUTLET RACK MOUNT POWER CONDITIONER WITH AUTO REBOOT - Manual (Page 3)

WATTBOX™ 600 SERIES Installation and Users Manual
pg.3
© 2012 Wattbox ™
LED OPERATION
PROTECTED
AUTO REBOOT
SYSTEM STATUS
INTERNET
POWER
GROUNDED
WB-400-IPCE-8
TM
PROTECTED
AUTO REBOOT
SYSTEM STATUS
INTERNET
POWER
GROUNDED
PROTECTED
AUTO REBOOT
SYSTEM STATUS
INTERNET
POWER
GROUNDED
WB-400-IPCE-8
PROTECTED
AUTO REBOOT
SYSTEM STATUS
INTERNET
POWER
GROUNDED
WB-400-IPCE-8
TM
PROTECTED
AUTO REBOOT
SYSTEM STATUS
INTERNET
POWER
GROUNDED
WB-400-IPCE-8
TM
Green (Solid): All sites/IP Addresses are communicating with the WattBox
Green (Flashing):
At least 1 (not all) Sites/IP Addresses are communicating with the
WattBox
Red (Solid): None of the Sites/IP Addresses are communicating with the WattBox.
When Illuminated:
Auto Reboot is Enabled, WattBox will perform power cycle for outlets that
are ON when communication with the assigned Website/IP Address is lost.
Note that outlets that are OFF, will not power cycle.
When Not
Illuminated:
Auto Reboot is Disabled, no power cycle will occur when communication
with the assigned Website/IP Address is lost.
Green (Solid):
WattBox processor is in an operating state and can be accessed via the
WattBox interface
Green (Flashing):
Firmware for the WattBox processor is being updated, during this state
the WattBox cannot be accessed via the WattBox interface.
Red (Solid):
WattBox processor is NOT in an operating state, reset button must be
pressed to return the WattBox to an operating state.
Green (Solid): Incoming AC outlet is grounded.
Off:
Incoming AC outlet is not grounded and requires inspection by an
electrician.
SAFE VOLTAGE
AUTO REBOOT
SYSTEM STATUS
INTERNET
PROTECTED
GROUNDED
SAFE VOLTAGE
ON OFF
WB-600-IPVCE-12
TM
Green (Solid):
The current incoming AC voltage is safe for operation, all outlets with
receive power.
Green (Flashing):
Unit is verifying incoming AC voltage, occurs at WattBox power up or
when incoming voltage returns to a safe condition after unsafe voltage
was detected.
Red (Solid):
Incoming AC voltage is NOT safe, the WattBox outlets will be off until a
safe incoming AC voltage is detected.
Green (Solid): The WattBox is powered on and outlets are protected.
Off:
The WattBox is not powered on, or the MOVs have opened removing
power from the outlets.
FRONT PANEL
DISPLAY LINK
1
2
1. Outlet – Supplies power to the WB-600-FP (Sold Separately)
2. Display Link – Data connection to WB-600-FP (Sold Separately)