Southern Folger A9300 MAXI-MORTISE - Manual (Page 2)

C38 Printed in USA FA Rev. 02-10
P.O. Box 2021, San Antonio, TX 78297 s Ph: 210.533.1231 s Fx: 210.533.2211
Web: www.SouthernFolger.com s Email: [email protected]
Trim Design______________
s Knobs – standard trim US26D.
Specify KR for knob and rose trim
with lock.
Dimensions: 2-1/4" diameter.
Safety knob: Specify “SK” knob and
side installed on.
s Lever handles – all lever handles
must be installed with track.
Material: Stainless steel.
Dimensions: 3/4" diameter x 4-11/16"
long.
s LeverTrak ® Handle Guide Sets –
LT and LTE Handle Guide Sets must
be specified. The track prevents
damage to mortise locks from over-
travel of the handle.
Material: Stainless steel.
s Roses
Material: Stainless steel.
Dimensions: 2-11/16" diameter,
concealed trim design.
s Secure escutcheon – SV 1/4" solid
stainless steel trim plates throughbolt
the door. Offered only with Builders
Hardware cylinder and A9300 Series
Lock.
EXAMPLE: SV-A9361 x SK inside
IMPORTANT NOTE: The secure
escutcheon trim package shown here
is available only with a Builders
Hardware cylinder (A9300 Series
Lock). This trim package is not
available with a Maxi-Mogul
® Cylinder.
FOLGER ADAM MECHANICAL LOCKS Key: Builders Hardware
Door: Swinging
Security
Level:
Minimum
A9300 MAXI-MORTISE ™
LT – Lever handles and track set
The “Lemont”
LTE – Lever handles,
track set and escutcheon
The “Limited”
KR – Knob and rose set
SV – Secure escutcheon
The “Stateville”
with KR – knob handle and rose
SV – Secure escutcheon
(inside) with SK – safety knob
and rose