Southern Folger NS400MCD MOTOR-OPERATED DEADBOLTS - Manual

FA Rev. 02-10 A29
For more information, please call 210.533.1231.
Description______________
NS400MCD is a pin tumbler, two-
position motor-operated deadbolt for
swinging doors. Specify builders
hardware cylinders and keying as
follows:
NS402MCD Keyed one side
NS406MCD Keyed both sides
Note: See optional features for either factory or
customer-supplied key cylinders. Model
NS400MCD, no cylinder supplied.
Applications____________
Specify for minimum/medium security
swinging cell or office areas of
institutions requiring deadbolt locks for
use in 2" wide hollow metal jamb
construction.
Operations______________
Locks or unlocks when motor is
energized by either a two or three-
position maintained contact switch.
Once unlocked, the deadbolt remains
retracted until selected to lock. Opening
and closing the door have no effect on
the lock. Non-fail-safe only. Holdback
switch prevents the deadbolt from
extending while the door is open.
Deadbolt is deadlocked upon closure of
the door.
Standards Compliance___
s UL1034 – Burglary-Resistant
Mechanisms.
s ASTM F-1577 Grade 1 Impact
Standard Features_______
s 300 lb. rated side load motor
operation – Precludes jamming by
applying side pressure on the door.
s Heavy-duty lock mechanism –
Designed to complement the high
torque motor. Corrosion-resistant
working parts tested over 1,000,000
cycles.
s Compact size – Specifically for hollow
metal frames with standard 2" face.
s Two-piece, twelve-pin plug
connector – Simplifies wiring, allows
pre-wiring of the lock opening.
s Stainless steel strike – Furnished with
tamper-resistant screws.
s Holdback switch – Does not allow
deadbolt to extend while door is
open.
s Mechanical unlocking by key –
Offers manual control at the door in
event of power failure, or at any other
time.
s Stainless steel deadbolt – 3/4"
throw, hardened to resist sawing.
s Faceplate finish – US32D satin
stainless steel.
s Indication switch – An internal switch
to monitor the positions of the
deadlock actuator. Signals deadlocked
condition.
Optional Features________
s Builders hardware key cylinders –
High security six-pin tumbler cylinder
may be specified. Special keying
requests will be accommodated, if
possible.
Note: Customer supplied key cylinders may be
used to adapt NS400 Series locks to a specific
keying system. These cylinders must have:
1. 1-5/32" diameter, full bar stock bodies.
2. 1-1/8" length, including cam.
3. Standard, removable Yale-type cam.
Cylinders and all keys should be sent to
Southern Folger Detention Equipment
Company and are required with cylinder
extenders.
s Key cylinder extension – Required
when lock is keyed on the stop side of
the door frame. Five standard lengths
are offered:
Jamb Cylinder
Size Extension
4-1/2" – 5" 4-3/4"
5" – 6" 5-3/4"
6" – 7" 6-3/4"
7" – 8" 7-3/4"
8" – 9" 8-3/4"
Note: Please specify appropriate cylinder
extension length when ordering. Special
lengths may be provided for other jamb
thickness. Contact factory for pricing and
availability.
s Finish – Key cylinder: US26D.
FOLGER ADAM ELECTRIC LOCKS Key: Builders Hardware
Door: Swinging
Security
Level: Minimum/Medium
NS400MCD
MOTOR-OPERATED DEADBOLTS