LevelOne WAP-0008 - Manual (Page 56)

56

RTS Threshold: The RTS threshold specifies the packet size of an
RTS transmission. This helps control traffic flow through an access
point, especially one with many clients. The setting value range is
from 1 to 2347, and default value is set to 2347.

Fragmentation: In a network, the maximum size or length of a
fragment is determined by the protocol used to transport the data.
This value should remain at its default setting of 2346. If you
experience a high packet error rate, you may slightly decrease your
"Fragmentation" value within the value range of 256 to 2346, even
number only. Setting the Fragmentation value too low may result in
poor performance.

DTIM interval: A Delivery Traffic Indication Message (DTIM) is a
countdown informing clients of the next window for listening to
broadcast and multicast messages. When the Access Point has
buffered broadcast or multicast messages for associated clients, it
sends the next DTIM with a DTIM Interval value. AP clients hear the
beacons and awaken to receive the broadcast and multicast
messages. Enter a value from 1 to 255 for DTIM. The default value
for DTIM interval is set to 3.

Preamble Type: The Preamble Type defines the length of the CRC
(Cyclic Redundancy Check) block for communication between the
Access Point and roaming wireless adapters.

SSID Broadcast: Enable or Disable a SSID broadcast. When
enabled, the SSID of Network Storage is sent to wireless enabled
devices on the LAN. This feature is enabled by default.
Then p
ress “Next” button, you could see the Wireless MAC Filtering setting.