beautypg.com

Urning on the, Onsole, Esting the – LevelOne KVM-0117 User Manual

Page 10

background image

7

change. This behavior is normal. You can readjust the image using the monitor on-screen controls. For
more information on the monitor on-screen controls, refer to Chapter 3. For more information on
configuring the display settings, refer to the manual that came with your video card.

2.3 Turning on the Console

Make sure all cables and the power cord are connected properly. Be sure to tighten all connector
screws. Using two hands, grasp the rear of the drawer, lift the tab and pull the panel up and forward.
Press the power button on the left of the monitor panel to turn on the console. The LED should turn to
green to indicate the console is powered on.

2.4 Testing the Console

To test that the console is working properly, perform the following steps:
1. Power up the console, and then turn on your computer.
2. Make sure the video image is centered within the screen area. Use the OSD controls to adjust the

image (see note below) or press the Auto button on the left side of the monitor.

Note: If the unit does not power up when the panel is pulled up, try pushing the soft power on/off
button on the left side of the monitor panel to power up the unit.

Note: You can adjust the horizontal and vertical position, contrast, and brightness to better suit your
video card and your personal preference. Refer to Chapter 3 for more information on using the
on-screen menu to adjust the video display

Before you start, make sure that all the devices you will connect have been turned off. To prevent
damage due to ground potential difference, make sure that all the devices during the installation
are properly grounded. Consult your direct vendor for any technical issues if necessary.

This manual is related to the following products: