LevelOne WAB-5120 - Manual (Page 57)

Figure 37 Restore Settings
Restore factory default settings via Reset Button
If software in the CPE is unexpectedly crashed and no longer reset the unit via Web, you may do
hardware reset via the reset button. Press and hold the button for at least 5 seconds and then
release it until the PWR LED gives a blink.
Reboot
You can reboot your CPE from “Configuration File” in “Management” as below:
Click “Reboot” and hit “Yes” upon the appeared prompt to start reboot process. This takes a few
minutes.
Figure 38 Reboot