Pole mounting, Figure 7 pole mounting, Step 1 – LevelOne WAB-5120 User Manual
Page 21: Figure 8 pole mounting, Step 2
Pole Mounting
1.
Turn the CPE over. Put the pole mounting rings through the middle hole of it. Note that you
should unlock the pole mounting ring with a screw driver before putting it through the CPE as the
following right picture shows.
Figure 7 Pole Mounting
– Step 1
2.
Mount the WAB-5120 300Mbps 5G Wireless Outdoor PoE Access Point/Bridge steadily to the
pole by locking the pole mounting ring tightly. The mounting ring supports pole diameter 32mm
to 70mm.
Figure 8 Pole Mounting
– Step 2
3.
Now you have completed the hardware installation of the WAB-5120 300Mbps 5G Wireless
Outdoor PoE Access Point/Bridge.