LevelOne WAB-5120 - Manual (Page 27)

Spanning Tree: Spanning Tree Protocol (STP) is a link management protocol for AP which
provides path redundancy while preventing loops in a network. STP allows only one active path at
a time between the access points but establish the redundant link as a backup if the initial link
fails.
STP Forward Delay: STP Forward Delay is the time spent in detecting and learning network tree
topology state before entering the forward state. Default time value is 1 sec.
GPS Coordinate Settings:
The GPS Coordinate Setting helps you mark the latitude and longitude of the Power R2 Extender.
Just enter the coordinates and click the Apply button.
TCP/IP Settings
Open “TCP/IP Settings” in “System” as below to configure the parameters for LAN which
connects to the LAN port of the CPE. In this page, users may change the settings for IP Address,
Subnet Mask, and DHCP Server.
Figure 12 TCP/IP Settings (Bridge)
Obtain IP Address Automatically: If a DHCP server exists in your network, you can check this
option, thus the WAB-5120 300Mbps 5G Wireless Outdoor PoE Access Point/Bridge is able to
obtain IP settings automatically from that DHCP server.
When the IP address of the CPE is changed, the clients on the network often need to
Note: