LevelOne IES-1081 - Manual (Page 88)

IES-1081 User Manual Page 88
no flowcontrol
4. Example:
The following example shows the use of flowcontrol on to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if )#flowcontrol on
switch_a(config-if )#
Port Status
1. Command Mode: Exec mode or Privileged Exec mode
Logon to Exec Mode (View Mode) or Privileged Exec Mode (Enable Mode).
The switch_a> or switch_a# prompt will show on the screen.
switch_a>
switch_a#
2. Usage:
Use the show interface command to display interface configuration and status.
3. Command Syntax:
show interface IFNAME
IFNAME specifies the name of the interface for which status and configuration
information is desired.
4. Example:
The following example shows the use of show interface to display interface configuration
and status of the interface fe1 (port 1):
switch_a>show interface fe1
Rate Control
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if )#
2. Usage:
Use this command to specify the ingress/egress rate to be used for each interface. The
bandwidth value is in bits.
Use the no parameter with this command to remove the ingress/egress rate to be used for
each interface.