LevelOne IES-1081 - Manual (Page 138)

IES-1081 User Manual Page 138
2. Usage:
Use ip igmp snooping report-suppression command to enable report suppression for
IGMP versions 1 and 2.
Use the no ip igmp snooping report-suppression command to disable report
suppression.
3. Command Syntax:
(no) ip igmp snooping report-suppression
4. Example:
The following example enables report suppression for IGMPv2 reports on vlan1.1:
switch_a(config)#interface vlan1.1
switch_a(config-if )#ip igmp version 2
switch_a(config-if )#ip igmp snooping report-suppression
switch_a(config-if )#
NTP
NTP Status:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use ntp enable command to enable NTP for the Switch.
Use no ntp enable command to disable NTP for the Switch.
3. Command Syntax:
(no) ntp enable
4. Example:
The following example enables NTP for the Switch:
switch_a(config)#ntp enable
switch_a(config)#
NTP Server:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage: