LevelOne WBR-6003 - Manual (Page 74)

74
Appendix B FAQ and Troubleshooting
What can I do when I have some trouble at the first time?
1. Why can’t I configure the router even if the cable is plugged in the ports of Router and the
LED is also lit?
A: First, make sure that which port is plugged. If the cable is in the WAN port, please change to plug
in LAN port 1 or LAN port 4:
Then, please check if your PC can get an IP address from the Router.
Click Start, Run
Type CMD and then click “OK”
Type ipconfig in the command prompt as shown below.
If you see that your PC has an IP address, then open your Web-Browser, and type 192.168.0.1 in
the address bar.
If not, please type ipconfig /release, then ipconfig /renew, to update your IP address.