LevelOne WBR-6003 - Manual (Page 61)

61
SNMP Setting
SNMP (Simple Network Management Protocol) is designed to give users the ability to remotely
manage a computer or network device.
To enable SNMP, please set the following:
•
Enable SNMP: You must check either Local or Remote or both to enable SNMP function. If
Local is checked, this unit will respond to requests from LAN. If Remote is checked, the unit
will respond to requests from WAN.
•
Get Community: Set the community of public. This will act as a password.
•
Set Community: Set the community of private. This will act as a password.
•
IP 1,IP 2,IP 3,IP 4: Enter the IP addresses of the managed PCs. The unit will send SNMP Trap
messages only to the IP addresses listed.
•
SNMP Version: Please select the SNMP Version of your SNMP Management software.
Click on Save to save the settings or Undo to cancel.