Analog Devices SHARC 82-000805-01 - Manual (Page 18)

Breadboard Area
1-2 SHARC EZ-Extender Manual
Switch (SW1)” on page 2-3 . The setup of the general-purpose signals
DAI_P15_GP1 and DAI_P16_GP2 is dependent on the specific ADC HSC
evaluation board being interfaced; therefore, the board’s model must be
taken into consideration.
The data bus of the EZ-Extender must be enabled before data is read.
Enable the data bus by a memory read from address
0x160 0000 , which
the
AD[15:0]
pins set up as the external port. Then, the
AD[15:0]
pins can
be set up in PDAP mode.
A list of ADC boards compatible with the extender can be found at
http://www.analog.com/processors/processors/blackfin/technicalL-
ibrary/manuals/pdf/EZ-Extender_to_DSP_Supported.pdf . Contact
Technical Support for information about available examples. To learn
more about Analog Devices data converters, go to
www.analog.com .
Breadboard Area
SHARC EZ-Extender broadens the range of the EZ-KIT Lite applications
by providing surface mounted (SMT) footprints for breadboard capabili-
ties and access to all of the pins on the EZ-KIT Lite’s expansion interface.