Alpine CDA-7892E - Manual (Page 7)

5
-EN
Display Angle Adjustment
Movable display
The movable display may be adjusted to 3 different
angles depending upon user preference.
1
Press the ANGLE 89 button to adjust the angle of the
movable display.
NOTES
• The display will close a half minute after the ignition key is
turned to the OFF position.
• The adjusted angle of the display is stored in memory. There
is no need to re-adjust the angle when the power is turned
back on.
CAUTION
Keep hands (or any other object) away from the display while it
is opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
Adjusting Volume/Balance (Between
Left and Right)/Fader (Between Front
and Rear)/Defeat
1
Press the MODE (Rotary encoder) button repeatedly
to choose the desired mode.
Each press changes the modes as follows:
Volume : 0 ~ 35
Balance : L15 ~ R15
Fader: R15 ~ F15
Subwoofer: 0 ~ +15
NOTES
• If the MODE button is not pressed within 5 seconds after
selecting the BALANCE, FADER, DEFEAT or SUBWOOFER
mode, the unit automatically returns to the VOLUME mode.
•∗ When the subwoofer mode is OFF, its level cannot be
adjusted.
2
Turn the Rotary encoder until the desired sound is
obtained in each mode.
By setting Defeat ON, previously adjusted settings of
BASS, Treble will return to the factory defaults, but MX
will be turned off.
Audio Mute Function
Activating this function will instantly lower the volume
level by 20 dB.
1
Press the MUTE button to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing the MUTE button again will bring the audio
back to its previous level.
Displaying Time
1
Press the CLK (clock) button repeatedly until the time
is displayed.
Each press changes the modes as follows:
Radio mode
CD Player/Changer modes
NOTES
• Selecting any tuner or CD function while in the clock priority
mode will interrupt the time display momentarily. The
function selected will be displayed for about 5 seconds before
the time returns to the display.
• When the power is off but the ignition key is on, press the CLK
button to display the time.
•∗ The display above is shown with a CD-TEXT compatible
changer connected.
Setting Time
1
In the Clock priority mode, press and hold the CLK
(clock) button for at least 3 seconds while the time is
displayed. The time indication will blink.
2
Turn the Rotary encoder to adjust the hours while the
time indication is blinking.
3
When the hour has been adjusted, press the Rotary
encoder.
4
Turn the Rotary encoder to adjust the minutes while
the time indication is blinking. The time is automatically
set 5 seconds after the minute adjustment. The time
can also be manually set by pressing the Rotary
encoder.
Playing time
mode → DISC TEXT
mode → → Clock priority
mode
TRACK
TEXT mode
←
TITLE mode
←
*
*
→ BALANCE → FADER → DEFEAT
SUBWOOFER*← VOLUME ←
→
Radio frequency
→ →
TITLE mode
Clock priority
mode