Alpine CDA-7892E - Manual (Page 16)

14
-EN
SETUP Operation
BAND
g DN f UP SETUP
Connecting to an External Amplifier
When an external amplifier is connected, sound quality
can be improved by stopping the power supply of the
buit-in amplifier. The power output is set to OFF by the
following procedure.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP or g DN button to select "PWR".
3
Press the BAND button to toggle the mode between
PWR ON and PWR OFF.
PWR OFF:
When activating the speakers, this setting can be
performed by connecting between the front and rear
pre-amplifier of the unit and the external amplifier. In
this setting, nothing is output to the speakers.
PWR ON:
The speakers are driven by the built-in amplifier.
NOTE
No sound is produced by the system when the power output is set
to OFF.
4
Press the SETUP button to return to normal mode.
Speakers
Front
left
Front
right
Rear
left
Rear
right
SPEAKER
RIGHT FRONT
SPEAKER
RIGHT REAR
SPEAKER
LEFT REAR
SPEAKER
LEFT FRONT
Amplifier
Amplifier
Front
left
Front
right
Rear
left
Rear
right