Alpine CDA-7892E - Manual (Page 14)

12
-EN
5
Press the MODE button repeatedly to select the
SUB-W mode.
Press the g DN or f UP button after selecting the
SUB-W mode, and the subwoofer output phase is
toggled SUBW NOR (0
°) or SUBW REV (180°).
6
Turn the Rotary encoder until the desired sound is
obtained in each mode.
Sound (Beep) Guide Function
This function will give audible feedback with varying
tones depending upon the button pressed.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP or g DN button to select “BEEP.”
3
Press the BAND button to toggle the mode between
BEEP ON and BEEP OFF.
NOTE
The initial setting at the factory is BEEP ON.
4
Press the SETUP button to set the selected mode.
Switching the Tuner Mode
The CDA-7892E incorporates the MAX TUNE SQ for the
highest quality tuner audio. Moreover, you can choose
between two settings to suit your own personal sound
preferences and usage.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP or g DN button to select
"NORMAL or HI-FI."
3
Press the BAND button to switch the TUNER mode.
HI-FI ←→ NORMAL
NORMAL: Standard setting
HI-FI: Sound quality priority setting
NOTES
• The initial setting at the factory is "NORMAL."
• If you find the sound is very noisy while listening to the tuner
in the HI-FI mode, we recommend you change to the
NORMAL mode.
4
When the setting is completed, press the SETUP
button to return to the normal mode.
Subwoofer On and Off
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP or g DN button to select “SUB
(Subwoofer).”
3
Press the BAND button to toggle mode between
SUB-W ON and SUBW OFF.
NOTE
The initial setting at the factory is SUB-W ON.
4
Press the SETUP button after setting the SUB-W ON.
SETUP Operation
f UP g DN
BAND
SETUP
Rotary encoder/MODE SOURCE
→ SUB-W → BALANCE → FADER
VOLUME ← DEFEAT ←