Alpine CDA-7892E - Manual (Page 29)

27
-EN
Installation
Caution
When you install this unit in your car, do not remove the
Detachable Front Panel.
If the Detachable Front Panel is removed during installation,
you might press too hard and warp the metal plate that holds it
in place.
1
Slide the mounting sleeve into the dashboard.
2
Reinforce the head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a clean
metal spot using a screw (
∗
) already attached to the
vehicle's chassis.
NOTE
For the screw marked ** , use an appropriate screw for the
chosen mounting location.
Metal plate
Detachable
Front panel
Mounting Sleeve
(Included)
Dashboard
Metal
Mounting
Strap
Chassis
Hex Nut (M5)
Bolt Stud
Ground Lead
∗∗
∗
CDA-7892E
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming from the
left rear of the CDA-7892E. Connect all other leads of the
CDA-7892E according to details described in the
CONNECTlONS section.
Slide the CDA-7892E into the dashboard. When the unit is
in place, make sure the locking pins are fully seated in the
down position. This can be done by pressing firmly in on the
unit while pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly locked
and will not accidentally come out from the dashboard.
Install the Detachable Front Panel.
Removal
1 Remove the DETACHABLE FRONT PANEL.
2 Use a small screwdriver (or similar tool) to push the
locking pins to the “up” position (see above drawing). As
each pin is unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do so.
Face Plate
NOTE
Secure the ground lead of the unit to a clean metal spot using a
screw (
∗
) already attached to the vehicle's chassis.
3
Lock Pin
Screw
Mounting Bracket
Ground Lead
Screws (M5 × 8)
(Included)
CDA-7892E
∗
CDA-7892E