IDEC MicroSmart AS-i - Manual (Page 18)

3: I NSTALLATION AND W IRING
M ICRO S MART AS-I NTERFACE M ASTER M ODULE U SER ’ S M ANUAL 3-5
Terminal Connection
Ferrules, Crimping Tool, and Screwdriver for Phoenix Terminal Blocks
The screw terminal block for the AS-Interface cable can be wired with or without using ferrules on the end of the cable.
Applicable ferrules for the Phoenix terminal blocks and crimping tool for the ferrules are listed below. The screwdriver is
used for tightening the terminal screws and mounting screws on the terminal block. These ferrules, crimping tool, and
screwdriver are made by Phoenix Contact and are available from Phoenix Contact.
Type numbers of the ferrules, crimping tool, and screwdriver listed below are the type numbers of Phoenix Contact. When
ordering these products from Phoenix Contact, specify the Order No. and quantity listed below.
Ferrule Order No.
Crimping Tool and Screwdriver Order No.
Quantity of Cables Cable Size Phoenix Type Order No. Pcs./Pkt.
For 1-cable connection
0.5 mm 2 AWG20 AI 0,5-8 WH 32 00 01 4 100
0.75 mm 2 AWG18 AI 0,75-8 GY 32 00 51 9 100
1.5 mm 2 AWG16 AI 1,5-8 BK 32 00 04 3 100
For 2-cable connection
0.5 mm 2 AWG20 AI-TWIN 2 x 0,5-8 WH 32 00 93 3 100
0.75 mm 2 AWG18 AI-TWIN 2 x 0,75-8 GY 32 00 80 7 100
Tool Name Phoenix Type Order No. Pcs./Pkt. Tightening Torque Description
Crimping Tool CRIMPFOX ZA 3 12 01 88 2 1 — For crimping ferrules
Screwdriver SZS 0,6 x 3,5 12 05 05 3 10
0.5 to 0.6 N·m For tightening terminal screws
0.3 to 0.5 N·m For tightening mounting screws
Caution
• Make sure that the operating conditions and environments are within the specification values.
• Be sure to connect the ground terminal on the CPU module to a proper ground, otherwise electri-
cal shocks may be caused.
• Do not touch live terminals, otherwise electrical shocks may be caused.
• Do not touch terminals immediately after power is turned off, otherwise electrical shocks may be
caused.
• When using ferrules, insert a wire to the bottom of the ferrule and crimp the ferrule.
• When connecting a stranded wire or multiple solid wires to a screw terminal block, use a ferrule.
Otherwise the wire may slip off the terminal block.