Harrington Hoists and Cranes SHB Trolley - Manual (Page 18)

18
Figure 3-5 Mounting Trolley Hoist on Beam End
3.3.3 Optional Method for the Trolley Hoist – If the trolley hoist cannot be mounted from the end of the beam,
complete the installation as follows:
1) Remove the Shaft Stopper Pin from Suspension Shaft (See
Figure 3-6 ).
2) If possible remove the outside Adjusting spacers and Reinsert the Shaft Stopper Pin. Spread the
trolley side plates apart.
3) Lift the trolley onto the beam so that Side Plate G (handwheel side) rests on the beam's flange.
4) Hold Side Plate G securely so that it does not come off the beam. Then push Side Plate S (hoist
side) onto the beam so that all four wheels rest on the beam's flange.
5) Replace the Outside Adjusting Spacers and the Shaft Stopper Pin. Insert Split Pin, bend the Split
Pin securely.
Figure 3-6 Mounting Trolley Hoist by Disassembly