Sonnet Technologies Tempo-X SATA 4+4 8-Port Serial ATA PCI-X Host Adapter Card - Manual (Page 6)

6
Quick Start Guide for Tempo-X SATA 4+4
Drive Formatting—RAID Arrays (continued)
4. Click the RAID tab in the Disk Utility window, select all the drives you
will use to create your RAID 0 (Stripe) array, and drag them into the disk
fi eld (Figure 9). Be careful to NOT accidentally drag in a drive you
don’t want included in the RAID.
5. From the drop-down menus, select the RAID scheme (stripe) and the vol-
ume format, and then type in the name for your RAID volume (Figure 9).
6. When the Creating RAID window appears, click the Create button; all
of the selected drives will be formatted and the RAID volume created
(Figure 10). Close Disk Utility; your drives are now ready to use and your
installation is complete.
Figure 9
Figure 10
Support Note: The remaining steps in this section describe the creation
of a RAID 0 (striped) array. If you intend to create a RAID 1 (mirrored)
array, the procedure is similar to the remaining steps. Please refer to Disk Utility
help for further information.