SKC 225-9808 Stick-to-it Lift Tape for Surface Sampling User Manual
Operating instructions, Stick-to-it
863 Valley View Road, Eighty Four, PA 15330
Tel: 724-941-9701 Fax: 724-941-1369
Stick-to-it
Lift Tape for Surface Sampling
1. Remove slide from slide mailer.
2. Document the sample location and other required information for the laboratory.
3. Peel off protective liner from slide to expose adhesive. (Pull liner from top down
for best results.)
4. Place slide adhesive side down on the surface to be sampled.
5. Gently press down to ensure contact is made.
6. Carefully remove slide from surface and place back into slide mailer.
7. Send slide to laboratory for analysis.
Operating Instructions
Form #40065 Rev 1102
SKC Limited Warranty and Return Policy
SKC products are subject to the SKC Limited Warranty and Return Policy, which
provides SKC’s sole liability and the buyer’s exclusive remedy. To view the complete