Archive – Ransburg MGS Multi-Gun Source 76789, 77046 User Manual

Page 13

CP-99-01

When a spraygun is triggered, the resulting air
flow closes the contacts of the air flow switch,
thereby activating the door mounted control unit to
output a signal capable of producing high voltage
at the spraygun. The reed switch contacts in the
spraygun handle also close when the spraygun is
triggered, thereby activating the MGS PC Board
to direct the output of the door mounted control unit
to the spraygun that has been triggered. When
one spraygun receives high voltage the MGS PC
Board locks out all other guns such that only one
spraygun may receive power from the control unit
at a given time.

When a spraygun is triggered, the resulting air
flow closes the contacts of that spray gun's internal
air flow switch, thereby activating high voltage at
the spraygun. Only one (1) gun may receive
power from the control unit at a given time.

MGS Multi-Gun Source - Installation

For MGS 2000C High Voltage Control

For MGS 2000C High Voltage Control
Unit

Unit

Connect supply air to the Air Supply port on either
side of the MGS unit. Attach the individual air lines
from each gun to the corresponding numbered air
ports on the side of MGS unit.

N O T E

The supply air should be clean, filtered

air, suitable for painting.

NOTES:

ARCHIVE