Archive, Inst, Loca – Ransburg MGS Multi-Gun Source 76789, 77046 User Manual

Page 10: Loca location tion tion tion tion

CP-99-01

MGS Multi-Gun Source - Installation

INST

INSTALLA

ALLA

ALLATION

TION

Figure 2a: High Voltage Module Bracket

Mounting for the MGS 2000C.

Install the MGS unit (and high voltage modules for
MGS 2000C) in a convenient area outside the
hazardous location, where it will be protected from
the possibility of environmental intrusion, such as
dust or moisture, and ambient temperatures do not
exceed 120

° F. The control unit may be mounted

As each installation is unique, this

information is intended to provide general
installation information for the MGS con-
trol unit. Consult your authorized ITW
Ransburg representative for specific di-
rections pertaining to the installation of
your equipment.

> The MGS control unit (and High Voltage
Modules for MGS 2000C) MUST

MUST

MUST be located

outside the hazardous area. (See National
Fire Protection Association Bulletin No. 33;
the Occupational Safety and Health Act of
1970, sections 1910.106 and 1910.107 and
ITW Ransburg Bulletin,

Operating Your Elec-

trostatic Coating System Safely.)))))

> The user MUST

MUST

MUST read and be familiar with

the SAFETY

SAFETY

SAFETY and SAFETY PRECAUTIONS

SAFETY PRECAUTIONS

SECTIONS

SECTIONS of this manual.

> This manual MUST

MUST

MUST be read and thorough-

ly understood by ALL

ALL

ALL personnel who operate,

clean or maintain this equipment! Special care
should be taken to insure that the WARN-

WARN-

INGS

INGS and requirements for operating and
servicing safely are followed. The user should
be aware of and adhere to ALL

ALL

ALL local building

and fire codes and ordinances as well as
NFPA Standard 33 and The Occupational
Safety and Health Act of 1970 (OSHA) prior to
installing, operating and/or servicing this equip-
ment.

DO NOT

DO NOT locate the control unit (or high

voltage modules for MGS 2000C) near or
adjacent to heat producing equipment such as
ovens, high wattage lamps, etc.

The high voltage modules should be mounted in
an upright position ONLY. The mounting bracket
76086-00 (supplied) can be used to mount the
high voltage modules.

To mount the high voltage module, first install the
76086-00 brackets as shown in Figure 2a. Then,
lift the high voltage module so that it's handle can
be inserted into the bracket slot, as shown in
Figure 2b. Next, lower the bottom of the high
voltage module until the handle comes forward in
the slot and the back of the module rests against
the wall.

N O T E

LOCA

LOCATION

TION

on the booth wall or where a convenient booth wall
penetration may be made.

W A R N I N G

C A U T I O N

For MGS 2000C

ARCHIVE