Archive, External connections, Input connections – Ransburg MGS Multi-Gun Source 76789, 77046 User Manual

Page 11

CP-99-01

Plug the AC line cord into a properly grounded
AC outlet.

The MGS control unit accepts universal, single
phase input voltage between 85 and 264 VAC. As
such, there is no need to change any switch
settings when changing input from 115 to 230 VAC
or vice-a-versa.

Figure 2b: Inserting Handle Into Bracket Slot for

MGS 2000C Only

EXTERNAL CONNECTIONS

Connect low voltage cables to the low voltage
cable sockets located on the side panels of the
MGS cabinet. Hand tighten only.

Hand tighten only.

Hand tighten only. Each voltage

line is individually numbered.

Connect the other end of the low voltage cable to
the handgun, using a wrench to tighten.

Connect low voltage cables to the low voltage
cable sockets located on the side panels of the
MGS cabinet. Hand tighten only.

Hand tighten only.

Hand tighten only. Each air and

voltage line is individually numbered.

Connect other end of low voltage cable to low
voltage cable connector on side of High Voltage
Module. Hand tighten only

Hand tighten only

Hand tighten only. Connect high

voltage cable from handgun to high voltage cable
socket located on top of the High Voltage Module.

DO NOT

DO NOT over tighten low voltage cable

connection to handgun. Damage to plastic
parts may occur.

MGS Multi-Gun Source - Installation

INPUT CONNECTIONS

In general, conduit must be used for

approved AC installation, however, if na-
tional and local codes permit, the AC
power may be supplied via the factory
installed line cord. If conduit is utilized,
the control unit wiring MAY be routed
through an optional explosion proof
switch mounted on or near the spray
booth where it will be convenient to the
operator.

N O T E

MGS units shipped from the factory

for 115 VAC input will have a 72771-06,
1 amp front panel fuse installed. While
MGS units shipped from the factory for
230 VAC input will have a 72771-01, 0.5
amp front panel fuse installed. If the other
input is required, it is recommended that
the fuse be changed in order to keep the
same level of protection.

N O T E

When connecting external wires to the

MGS unit, route the wiring through the
external wiring hole located on the bot-
tom of the unit.

Voltage Output

oltage Output

For MGS 2001 Low Voltage Control Unit

C A U T I O N

For MGS 2000C High Voltage Control

For MGS 2000C High Voltage Control
Unit

Unit

Crimp the appropriate connector onto the ground
wire assembly and install from the MGS unit
ground stud, located on the bottom panel, to a true
earth ground.

For MGS 2000C control units it is also necessary
to install a ground wire from each High Voltage
Module to earth ground. To do so, crimp the

Safety Ground

ARCHIVE