AMT Datasouth Codewriter 4500 Series - Manual (Page 70)

Troubleshooting Guide
60
this issue involves lowering the Black Bar Sensor Sensitivity to a level that
will allow the sensor to detect the black bars between labels.
1. Press the
ONLINE
PAUSE key. This takes you to the off-line menu.
2. When Interface Status Off-Line is displayed, press the
MENU
key. This
will take you the to the Print Parameters menu.
Press the
ITEM
FEED
key until the Bar Sense parameter displayed.
3. Press the
CANCEL
key to lower the value by 10%.
4. Press the
ONLINE
PAUSE key. The display will read ENTER to save new defaults.
Press the
ENTER
PRINT
key to save these values.
5. Press the
ONLINE
PAUSE key. This will take the printer off-line.
6. Press the
ITEM
FEED
key. If the label feeds correctly repeat the procedure one
additional time to lower the value by an additional 10%. If however, the
Media Feed Fault message still occurs, press the
CANCEL
key and repeat
the procedure again.
If this procedure fails to produce a working sensor sensitivity that stops the
Media Feed Fault messages contact qualified service personnel.