KISAE HS 1800-60 Home Solar Kit - Manual (Page 12)

Page 12
press and hold ‘Power’ and ‘Select’ button together for 5 seconds to exit the setting
mode. If you wish to keep all the previous settings on inverter, charger and alarm,
just press ‘Power” button for 1 seconds and press and hold ‘Power’ and ‘select’
button together for about 5 seconds to exit the feature setting mode.
Note: Pr ess and hold ‘Power’ and ‘Select’ button together for 5 seconds at any time to
exit the feature setting mode. See feature setting chart below.
5. OPERATION
WARNING: RISK OF EQUIPMENT DAMAGE

Do not plug surge-
protected power bars into the unit’s 120 VAC outlets.

Do not connect an AC power source to the 120 VAC outlets.
 Do not connect the unit’s AC power input cord to its 120 VAC outlets.
Operating the main unit
Mode Status
LED
Display Condition
Full
Automatic
In1,Ch1,
Solid
green
“Ful”
AC output is supplied by utility AC power
Internal battery is fully charged
Flashing
Flash “XX”
AC output is supplied by utility AC power