Getting started, Onnect your, Maestro – Gentec-EO PC-MAESTRO (Old Software for MAESTRO) User Manual

Page 17: To the, Pc-maestro, O disconnect your, Orrect, Port to plug a, To a

PC-

MAESTRO User’s Manual Revision 1.0

GETTING STARTED

4.1 Connect your MAESTRO to the PC-MAESTRO.

1. Connect your MAESTRO to the PC using a USB cable. Use the correct port as identified in the

picture below.

2. Install the PC-MAESTRO on the PC.
3. Power up the MAESTRO
4. Start the PC-MAESTRO
5. Click on the

“Connection” button in the Main Controls ribbon. The software will scan each port on

your computer and connect the PC to the first port connected to a MAESTRO.

Fig. 3-10 Correct USB port to plug a MAESTRO to a PC

4.2 To disconnect your MAESTRO

Click on the “Disconnect” button in the main controls ribbon.

4.3 To change the measurement settings of your detector head

To change the behavior of the detector head plugged into a MAESTRO, go to the

“Set Measure” tab

panel.