Gentec-EO HP - Manual (Page 5)

Version 2.2
1
HP Series Instruction Manual Gentec Electro-Optics Inc. All rights reserved
1. HP SERIES POWER DETECTORS
1.1. INTRODUCTION
The Gentec-EO HP Series power detector family includes HP100A-3KW-HE, HP100A-4KW-HE,
HP60A-10KW-GD and HP100A-12KW-HD.
- The HP100A-3KW-HE detector has dimensions of 127 mm x 127 mm and an aperture
of 100 mm.
- The HP100A-4KW-HE detector has dimensions of 127 mm x 127 mm and an aperture
of 100 mm.
- The HP60A-10kW-GD detector has dimensions of 127 mm x 127 mm and an aperture
of 60 mm.
- The HP100A-12KW-HD detector has dimensions of 127 mm x 127 mm and an
aperture of 100 mm.
- The high power surface absorber sensors are designed for use at high average power
densities.
The HP detectors can measure between
- 100 W and 3 KW of average power for HP100A-3KW-HE,
- 100 W and 4 KW of average power for HP100A-4KW-HE,
- 300 W and 10 KW of average power for HP60A-10KW-GD.
- 300 Wand 12 KW of average power for HP100A-12KW-HD.
*For lower power, consult Gentec-eo
The HP-D0 detectors are supplied with a 180 cm length flexible cable with output connection options
of a DB-15 "intelligent" male connector.
NOTE: To eliminate possible damage, do not carry the detector using the connector cable.
Some HP detectors are supplied with a stand (optional).
For cases where Gentec-
EO’s monitors don’t automatically read the wavelength correction factor,
you can use your detector’s “Personal wavelength correction TM
Certificate ” to adjust the power you
read to a power corrected for a particular wavelength.
Call your nearest Gentec-EO distributor to replace the sensor disk and/or to recalibrate the head.
For Gentec-
EO’s nearest office contact information, see p. ii, Contacting Gentec Electro-Optics Inc.