General Tools and Instruments TI872 - Manual (Page 2)

SETUP INSTRUCTIONS
1. Remove the plastic film from the display.
2. Turn the unit over and open the battery
compartment by sliding the white plastic cover
above the magnet in the direction of the arrow.
3. Install the supplied “AAA” battery in the
compartment using the + and – marks inside the
compartment as a guide.
The beeper will sound quickly four times. If you
have not moved the function switch on the right
side of the unit from its factory-set CLOCK
position, the display will show a running clock
beginning at 12:00:00 AM. If you have moved the
function switch to another position, the display will
show 0:00:00.
4. Replace the battery compartment cover.
TO SET THE CLOCK
1. Make sure the function switch on the right side of
the unit is in the CLOCK position. Press and hold
the large START/STOP button on the right side of
the front panel. The beeper will sound once and all
six display digits will begin blinking once per
2