General Tools and Instruments MMH800 - Manual (Page 11)

MAINTENANCE TIPS
The battery charge icon at the upper right of the display shows two bars
when the voltage of the installed battery is between 7.25 and 9V. When the
charge drops to between 6.3 and 7.25V, the icon will show only one bar on the
right, like this:
When the battery charge drops below 6.3V: 1) the last bar of the icon will begin
flashing, 2) the beeper will sound repeatedly, and 3) the unit will automatically
power itself off in 15 seconds.
It is now time to replace the battery by following the Setup Instructions on p. 7.
When the tips of the meter’s factory-installed 5mm test pins show signs of
wear, replace them with a pair of 10mm or 15mm pins included in the case.
Remove the battery when storing the meter for an extended period of time.
Do not drop or disassemble the meter or immerse it in water.
WARRANTY INFORMATION
General Tools & Instruments’ (General’s) MMH800 4-in-1 Pin/Pad RH Moisture
Meter is warranted to the original purchaser to be free from defects in material
and workmanship for a period of one year. Subject to certain restrictions,
General will repair or replace this instrument if, after examination, the company
determines it to be defective in material or workmanship
This warranty does not apply to damages that General determines to be from
an attempted repair by non-authorized personnel or misuse, alterations, normal
wear and tear, or accidental damage. The defective unit must be returned to
General Tools & Instruments or to a General-authorized service center, freight
prepaid and insured.
Acceptance of the exclusive repair and replacement remedies described herein
is a condition of the contract for purchase of this product. In no event shall
General be liable for any incidental, special, consequential or punitive damages,
or for any cost, attorneys’ fees, expenses, or losses alleged to be a
consequence of any damage due to failure of, or defect in any product
including, but not limited to, any claims for loss of profits.
11