General Tools and Instruments DTC500 - Manual (Page 4)

SNOOZE
Press SNOOZE to trigger snooze alarm. To stop alarm for
one day, press any key on the unit.
MAX/MIN MEMORY
Press the ”MAX/MIN“ button to view the maximum
values for 5 seconds, press again to view the
minimum memory. To clear the memory record,
press “CLEAR/ALARM” while the respective values
are displayed on screen.
TEMPERATURE TREND INDICATOR: The 3 icons will
indicate Rising, Steady, Falling if the temperature
change is more than 1 degree in an hour.
TEMPERATURE ALERT
(available for desktop models only)
Press “ALERT” to turn temperature alert on and off.
Hold “ALERT” 3 seconds to enter the alert setting mode.
The indoor channel and the Upper + Lower pointers
flash.
Press “+, - ” to select the indoor or Ch1, 2, 3 and press
“ALERT“ to confirm the channel. The Upper pointer and
temperature will flash, enter the desired upper limit with
the “ +, - ” buttons, press “ALERT” to confirm and go to
the lower limit setting.
The Lower pointer and temperature will flash, enter the
desired lower limit with “ +, - ” buttons, press “ALERT”
to confirm and exit.
Each setting cycle will allow setting one channel for the
temperature alarm. The unit allows you to enter a
temperature alert for the indoor channel and each of
the Channels 1, 2 and 3.
When temperature hits the limit of the preset, the Upper
& Lower pointers and the temperature of the respective
channel will flash, Press any key to stop the alarm.
LOW BATTERY INDICATION
Low battery indication is available for the home unit and
for all of the 3 remote channels. Replace the batteries
and follow the setup procedure as mentioned in this
instruction manual.
BATTERY DISPOSAL
Replace only with the same or equivalent type
recommended by the manufacturer.
Please dispose of old, defective batteries in an
environmentally friendly manner, in accordance with
the relevant legislation.
DTC500 Manual -FINAL-91307 9/13/07 4:29 PM