General Tools and Instruments DBAR880 - Manual (Page 2)

NAME AND FUNCTIONS OF BUTTONS:
Press Functions Hold 3 seconds
CH Select Channel 1,2,3 Delete current channel
SET Zone Time/Home Time Enter clk & cal setting
AL Read Alarm time 5 sec Alarm set setting
MEM Read maximum/ minimum temperatures, humidity
+ 1 step forward Fast advance
Alarm on/off
- 1 step backward Fast backward
°C/°F R/C On/Off
Zz Trigger snooze alarm & extended backlight
BARO Nil Enter altitude
̆
Select hPa/inHg altitude
Adjust altitude level
̄
Step backward for altitude
Adjust altitude level
BATTERY INSTALLATION
HOME RECEIVER:
Lift off the battery cover at the back, install 2 “AA” batteries according to the polarity
indicated, close the battery cover.
REMOTE SENSOR:
Lift off the bracket stand, loosen the 4 screws with a small screwdriver, insert 2
“AAA” batteries according to the polarity indicated. Replace the cover and tighten
the 4 screws.
SETTING UP THE WIRELESS THERMOMETER:
• For the first installation, always insert batteries to the home unit and then the
remote sensor. Set Channel 1 for the first remote sensor. Set channel 2 and
channel 3 for the 2nd and 3rd sensor.
• Press the Tx button on the back of remote sensor to verify the RF reception.
• If more than 1 sensor is connected, press “CH” to select Ch1, Ch2, Ch3.
°C/°F SELECTION, TIME
Press “ – ” to select ºC/ºF
MOON PHASE
Moon phase will be displayed automatically according to current calendar.
SETTING UP THE BAROMETER
When power up, the air pressure (based on your current altitude level) will be
displayed.
To offset the reading to sea level pressure, hold “BARO” button for 3 seconds.
“0” meter will flash, set the approximate altitude of your existing location using
“
̆
” and “
̄
”. For example, you may enter 100 meters if you are living in a building
DBAR880 MANUAL-FINAL-91307 9/13/07 4:28 PM Page 2