General Tools and Instruments AQ150 - Manual (Page 8)

To detach the unit (to change the battery, change the temperature unit, or reset the high and/or low
alarm limits), grab it and pull until the two Velcro strips separate.
EXTEND AND SECURE THE PROBE
Remove the twist tie keeping the probe cable in a bundle. Extend the probe cable to the desired
length.
To install the remote probe in an aquarium,
1) Slid e the probe tip through the hole in the base of the suction cup.
2) Press the suction cup firmly against the glass inside the aquarium about 4 in. (100mm) below
water level.
To attach the probe to the inside of a refrigerated case or heating table, or to the outside
of a window,
1) Slide the probe tip through the hole in the base of the suction cup.
2) Moisten the inside of the suction cup and press it firmly against the inside frame or glass of
the refrigerated case, heating table or window.
To attach the probe to a wooden outside window frame or apron,
1) Slide the probe into the channel of the supplied black plastic bracket. Push the probe until its
tip reaches the end of the channel.
2) Using the supplied Phillips-head wood screw, secure the bracket to the frame or apron.
8