Finish Thompson S1, S2, S3, S4 - Manual (Page 5)

Safety
1. Introduction
This manual contains all the information needed for the correct installation, use and maintenance of your new Finish Thompson
motor. It should be read and understood by all the personnel involved in installation, operating and servicing of the pump before it
is started.
2. Operator Qualification and Training
The personnel in charge of the installation, the operation and maintenance of the pump/motor must be qualified and able to
perform the operations described in this manual. Finish Thompson Inc. shall not be held responsible for the training level
of personnel and for the fact that they are not fully aware of the contents of this manual.
3. Safety Instructions
FOR YOUR OWN SAFETY
BEFORE using or servicing your pump, please make sure to wear the proper clothing, eye protection and follow standard safety
procedures when handling corrosive or personally harmful materials.
GENERAL DANGER
NEVER use a plastic pump or an open, splash-proof, TEFC or non-ATEX motor when pumping or mixing flammable or combus-
tible material.
ALWAYS use a Model EFS 316SS pump tube with Model S4 air motor and static protection kit with grounded discharge hose,
P/N 107429, when pumping or mixing flammable or combustible material. Follow Assembly, Installation & Operating Instruc-
tions from manual, P/N J102721, included with the static protection kit or it can be accessed online at www.finishthompson.
com/downloads.
ALWAYS use and store the pump and motor in an upright position.
DANGER: POWER SUPPLY
NEVER perform any maintenance operation on the motor while it is running or before it has been disconnected from the
power supply. Avoid any possible hazard that might be caused by electric power.
ALWAYS check the electrical specifications on the motor data plate and make sure they correspond to the power supply to
which it will be connected.
ALWAYS place motor in the OFF position prior to connecting the power source.
NEVER immerse the motor in liquid.
4. Noise Level
S1, S2, and S3 electric motors in normal operating conditions produce a sound level equal to or less than 74 dBA at a distance
of three feet (~ one meter). S4 Air motor produces a sound level equal to or less than 78 dBA at a distance of three feet (~ one
meter)
5. Modifications and Spare Parts
Any changes concerning the service of the motor/pump as originally purchased can be executed only after written approval
from Finish Thompson Inc. It is recommended to use only genuine Finish Thompson Inc. spare parts and approved accessories.
The use of non-original spare parts or non-approved accessories will void warranty and remove any responsibility on the manu-
facturer’s behalf for any damage caused to people or things.
3