Fairbanks VSX SERIES TRUCK SCALE - Manual (Page 9)

Section 1: General Information
04/12 9 51173 Rev. 8
Electronic Component Care
Much of the equipment consists of printed circuit assemblies, which must be
installed using
ESD handling procedures.
These assemblies must be replaced as assemblies or units.
Replacement of individual components is not allowed.
The assemblies must be properly packaged in ESD protective material.
These components must be returned intact for replacement credit per normal
procedures.
All electronic and mechanical adjustments are considered to be part of the
installation, and are included in the installation charge(s).
Included is any required computer programming or upgrades.
Included are any accuracy and/or operational specification changes.
Do not remove power from this unit unless it is performed by the proper shut down
method. Failure to comply with the proper shut down procedures can result in
damage to the hard disk drives or data.
The AC receptacle / outlet shall be located near the instrument and easily accessible.
Electrical connections other than those specified may not be performed.
Conferring with Our Client
Before the installation is considered complete, the equipment is to
be programmed to meet or exceed any applicable weights and
measures requirements.
The technician must be prepared to recommend the arrangement of components
which provide the most efficient layout, utilizing the equipment to the best possible
advantage.
The warranty policy must be explained and reviewed with the customer.